YEAR MAKE MODEL HOURS PRICE
2008 CATERPILLAR D11T 20520 Rental Ready
 

This Cat D11T features:

  • Complete rebuild at 18,122 Hrs - Engine not replaced at time of rebuild
  • Factory Engine at 19,654 Hrs
  • Complete extreme service U/C at 19,654 Hrs
  • Operator catwalk system installed
  • Fire suppression system installed and maintained to mine standards
  • Single Shank Ripper
  • Rebuilt U Dozer

This Caterpillar D11T crawler tractor has had the following procedures performed:

Drivetrain

  • Engine installed 19,654 Hours - New Factory Drop in Engine
  • Below work was completed at 18,122 Hrs
  • torque converter - replaced with complete rebuilt component
  • transmission - complete recondition c/w all bearings & seals
  • powertrain & torque converter scavenge oil pumps replaced with new
  • powertrain lines & hoses - all damaged or leaking lines &/or hoses replaced,
  • new seals at all connections
  • final drives - inspected / reseal & rebearing as required
  • radiator - all cores sent out for clean & test / reinstalled with all new seals
  • fluids & filters (all) replaced with new
  • battery & wiring - all systems in starting, lighting, monitoring & control inspected /
  • any damage repaired & tested to insure all systems are functioning correctly

Hydraulic System

  • Following hyrdraulic work performed at 18,122 hrs
  • implement pump - replaced with Cat reman
  • fan pump - reconditioned complete
  • fan motor - replaced with Cat reman
  • bulldozer lift cylinders (2) rebearing & reseal complete
  • bulldozer tilt cylinders (2) rebearing & reseal complete
  • hydraulic line & hoses - all damaged or leaking lines &/or hoses replaced, all new
  • bulldozer tilt hoses on blade section, new seals at all connections

Undercarriage

  • Done at 18,122 Hrs - all bogie pins (32) major & minor replaced with new
  • Following work performed at 19,654 Hrs
  • All new track rollers
  • New idlers 
  • Sprocket segments replaced with new 
  • Track groups - replaced with new trackt groups c/w 28 inch shoes
  • Pivot shaft - all bearings in track frames & main frame replaced with new
  • Equalizer bar - all pins, seals & bearings (both ends & center) replaced with new

Ripper

  • Rebuilt Ripper installed at 18,122 Hrs
  • single shank ripper c/w hydraulic pin puller & push block
  • cylinders all (4) completely reconditioned
  • all hydraulic hoses on ripper are new

Bulldozer

  • Blade Rebuilt at 18,122 Hrs
  • Low Hours on Blade rebuild - in like new condition
  • universal c/w dual tilt cylinders & rock guard
  • face, frog & pin bores rebuilt to new specification / replace face wear strips
  • all worn pins replaced with new

Cosmetic

  • Work done at 18,122 Hrs
  • Cab fully refurbished
  • Tractor straightened and painted to new standards
IMAGE GALLERY (click image to enlarge)